poe-world
GAT-12v25w Gigabit PoE Splitter 1000Mbps Ethernet Speed Power Over Ethernet Splitter with 12 Volt 25 Watt Output for 12V Non-poe Devices
GAT-12v25w Gigabit PoE Splitter 1000Mbps Ethernet Speed Power Over Ethernet Splitter with 12 Volt 25 Watt Output for 12V Non-poe Devices
Couldn't load pickup availability
Convert and Split Power and Data to 12V DC and Gigabit Data on Ethernet Output
This device works with any 802.3at switch, it takes the 44 to 56 volts from the PoE switch, and converts that voltage to 12 volts and removes power from the data - it works with gigabit data speeds. Can also work with an 802.3af switch if the ouput is used below 13 watts.
Intended for use with Cisco or similar PoE switches – this PoE solution appears like a standard Class 4, 25 watt device. The PoE switch can send either polarity, and only 2 pairs are required for power, 4 pairs for gigabit data, 2 pairs for 10/100.
The ouput is fully isolated from the input voltage. Grounding is of no concern. The ouput power is on a DC connector.
Specifications
Data speed: 10/100/1000 mb/s
Input Voltage: 802.3af / 802.3at / passive 44 to 57 volts at 570 mA max
Output Voltage: 12 volts +- 2% at 2.08 amps, 25 watts
Internal power use: 350 mw ( keep alive 802.3af)
Operating Temperature: 0°C - 50°C
Data: Transparent
Isolation: 1500 Volts
Size: 107 x 50 x 25 mm
802.3at: Class 4
PoE Power input Pins: 1&2 and 3&6 – either polarity – mode A
4&5 + and 7&8 minus – mode B
Shielded RJ45
Data output: Shielded RJ45
Power out DC connector: 2.1 mm x 5.5mm female connector
LED status on Female RJ45: Right - Power In active = Green
Left - Power out active = Amber
Introduce your content
Answer your customers' common questions
List a frequently asked question
Then provide an answer that will help your customer make an informed purchase.